A new Power Supply for the Cold Fusion Reactor by JL Naudin

A new Power Supply for the Cold Fusion Reactor
created on May 8, 2003 - JLN Labs - Last update June 2, 2003
Toutes les informations et schémas sont publiés gratuitement ( freeware ) et sont destinés à un usage personnel et non commercial
All informations and diagrams are published freely (freeware) and are intended for a private use and a non commercial use.

You will find, in this page, some very helpfull advices for suppressing the RF/EMI noise produced by the strong plasma electrolysis underwater in the Cold Fusion Reactor ( CFR ). This will give you more accurate measurements of the current flow and thus better measurements about the Electrical Power INPUT. This new power supply works very well with the Cold Fusion Reactor v3.0 with a 0.2 M solution of K₂CO₃. With the new PS design presented in this page, you will be able to use a common digital ammeter or a simple analog ammeter for the current measurement. The current is measured between the RF/EMI filter and the bridge rectifier. See the diagram below :

The RF current produced by the plasma is fully filtered by the RF/EMI filter ( a Corcom type 5K1 )
and some capacitors ( C2 and C3 ) placed between the CFR and the power supply.

This New CFR Power supply has been tested successfully with the Digital Oscilloscope Fluke 123 and its current clamp CIE model CA-60A. The Power input measurement and thus the efficiency of the CFR is still in line with all the previous tests.

The measured current with the scope has been compared with the current measured with an Analog ammeter ( see below ) :

The measured current with the scope has been also compared with the current measured with a Digital ammeter ( see below ) :

So, this new enhanced CFR-Power Supply can be fully used for testing the Cold Fusion Reactor with various and common equipments...

I wish you a good Cold Fusion Reactor replication experiment and a high efficiency...

Disclaimer : The author assumes no liability for any incidental, consequential or other liability from the use of this information. All risks and damages, incidental or otherwise, arising from the use or misuse of the information contained herein are entirely the responsibility of the user. Although careful precaution has been taken in the preparation of this material. Be Carefull, you must conduct this test in a well ventiled room or better in open air, you must not smoke during the test. This experiment is not intended for the inexperienced. User of this document should be very carefull to try anything out ! If you do it, the risk of any results is just yours. I take no responsibility of anything that might happen, let it be of a wrong information or anything else.